Help
Check a model from Autodesk Construction Cloud
Pick a model version straight from your Autodesk project, with no export. It is read in your browser, with your own Autodesk sign-in. Our server never contacts Autodesk.
- Who can do this
- Every member of a firm on the Business plan.
- Open Check a model. Under “Where the model comes from”, choose Autodesk Construction Cloud.
- Select Sign in to Autodesk and finish signing in in the Autodesk window. If the window does not open, allow pop-ups for this site.
- Under Choose a model, open the account, the project and the folders, then pick the model and its version.
- Select Check this model. The model is read from Autodesk into this browser.
- Read the result with “Read a result: simple and expert view”.
- To stop, select Disconnect. The sign-in also ends when you close the tab.
What you should see
The same result as a file check. The line “What left your browser” says what was sent. The Autodesk sign-in stays in this tab. It is never given to us.
Notes
You only see what your own Autodesk rights let you see. Autodesk reads published Revit 2024 or later models. The code data check does not run on a model read from Autodesk yet; the data and handover checks run as usual. If you see “We could not reach Autodesk. Check your sign-in and try again.”, sign in again and retry. On another plan, the source says it is on the Business plan. The local program can also read a version from Autodesk: see “Check a model from a watched folder”. Each model read from Autodesk is listed in the Library with an Autodesk tag, with its versions and the comparison of two runs. It cannot be renamed, filed in a project, labeled or deleted there, and file health and the BCF file do not apply to it.
Write the status back to Autodesk
An owner or a manager can add BIMgravity’s own property set, BIMgravity_Status, to the elements of the version that was checked. Each element gets one fixed word: “Points to correct” or “No point found”. It is written from your browser with your own Autodesk sign-in; our server receives only the counts. Your model’s own parameters are never changed. The status is kept by Autodesk beside the model’s data: it is not saved into the Revit file, so it does not show inside Revit.
- Check a model from Autodesk and wait for “Saved to your firm's history”.
- Under Write the status back to Autodesk, select Switch on write-back. It is off until an owner or a manager switches it on for the Autodesk account, and it needs a sign-in less than ten minutes old. If you are asked to sign in again, do so and check the model again.
- Select Prepare the write and read the preview: the version, the property set, how many elements get each word.
- Select Write to confirm. Autodesk asks you to sign in once more to allow the write; that sign-in ends right after it.
- Read the result: how many elements were written. If Autodesk stops, the count says how many were written and nothing else is tried.
Notes
Only the version that was checked is written: if a newer version was published since, nothing is written. A write is limited to 5,000 elements. The report of the check then shows what the browser or the local program reported: who wrote the status, when, and for how many elements. Write-back is on the Business plan. The local program does the same with --write-status (a preview only) and --confirm (the write).